KI Trek Assembly Instructions

leg
leveling
glide
Figure 1
short-fold
adapter plate
leveling
glide
standard
TT-base
Figure 2
Assembly Instructions
TT-Base Folding Table
Trek™, Datalink ® Multipurpose, Barron
#14 x 1"
wood screw
TT-base
vertical leg
wireway
#14 x 1"
short-fold
screw
TT-base
table top
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
® & Portico™
July 2013
Tools Required
• Phillips Screwdriver
Hardware Included
• (8) #14 x 1" Wood Screws
• (4) Glides
Note: The instructions below
illustrate the assembly of both the
folding TT-base (Figure 1) and the
short-fold TT-base (Figure 2).
The item that is required to make
the base a short-fold base is the
short-fold adapter plate (Figure 2).
It is only on one base of each pair.
The adapter plate allows the folded
leg to be clamped shut while
overlapping the opposite leg.
1. Place the table top upside down
onto a soft protective surface
(Figure 1).
2. Locate the four pre-drilled holes
at each end of the table. Align
the holes of each base with the
pre-drilled holes in the table.
The folded legs of the bases must
be positioned toward the center of
the table (Figure 1). If installation
requires a short-fold base
(Figure 2), the short-fold leg must
be positioned over the standard leg.
3. Secure the bases to the table
with four #14 x 1" wood screws
provided, not to exceed 60 in/lbs of
torque (Figures 1 & 2).
4. Screw two leveling glides into the
threads at the bottom of each leg
(Figures 1 & 2).