Operation; Device Display - Victron energy Isolated SmartSolar MPPT RS 450/100 Manual

4. Operation

4.1. Device display

The unit has an LCD screen that displays operational information. The screen cycles through the relevant displays every few
seconds.
Startup Screen
When the units is first switched on it will display firmware, serial number and model details for severals while the unit performs
self tests.
Battery:
Battery Power, Current, DC voltage, Temperature (*), State-of-charge (*) and Time-to-go (*). Battery state (e.g. discharging, bulk,
absorption, float, etc).
(*) These items are only visible if the data is available.
Solar 1
Solar Power, Voltage and Current, kWh daily and total Yield.
Additional MPPT Solar Trackers
Additional solar trackers will display the same values as above where available on additional screens.
Errors, Warnings and Alarms
The system will display code notifications as required. See troubleshooting section for additional information.
In the top right of the display are other system information icons.
Page 16
Isolated SmartSolar MPPT RS
Communicating on any interface (e.g., Bluetooth, VE.Can, etc.)
Bluetooth Enabled, Icon colour changes when connected
MPPT Active
(Blinking) Error or Warning
Battery, fill corresponds with voltage, blinks when empty
Operation