Acom 1000 User Manual page 10

PRECAUTIONS:
The amplifier works with high voltages up to 3000V, which are LETHAL!
For your safety, pull the amplifier power plug out of the mains wall outlet and WAIT AT
LEAST 30 minutes EACH TIME BEFORE you remove the cover of the amplifier. Do not
touch any part inside while the amplifier is open because some residual voltages may
still be present.
Never allow anyone, ESPECIALLY CHILDREN, to push anything into holes in the case -
this will cause electric shock. NEVER TOUCH AN ANTENNA during transmission - this
may result in an electric shock or burn. NEVER EXPOSE the amplifier to rain, snow or any
liquids. AVOID placing the amplifier in excessively dusty environments or in direct
sunlight. DO NOT OBSTRUCT AIR INTAKE (rear panel) and EXHAUST (top cover) areas of
the amplifier. Keep a minimum distance of 10cm (4 inches) to the intake and 50cm (20
inches) to the exhaust.
Внимание!
Danger!
Do not undertake on your own repairs or changes in hardware or software of the
amplifier in order not to endanger your or other's health and life and not to damage the
amplifier and the equipment connected with it, not covered by warranty. The
manufacturer is not liable for another's actions and responsibility shall be assumed by
the doer.
Внимание!
Danger!
To avoid damage (not covered under warranty) read the Section
User's Manual carefully. If you have any doubts about the installation, operation or
safety of the amplifier, please consult your dealer.
Page 10 of 36 | S e c t i o n GENERAL INFORMATION
D A N G E R ! H I G H V O L T A G E !
D A N G E R ! H I G H V O L T A G E !
D A N G E R !
W A R N I N G
User's Manual | ACOM 1000 | HF + 6m Linear Amplifier
2 INSTALLATION
of this
August 2020