Settings For Dp-Slaves - Mitsubishi Electric MELSEC iQ-R Series User Manual

Settings for DP-Slaves

Set for DP-Slaves that configure the PROFIBUS-DP network.
For DP-Slaves that use the RJ71PB91V, connect the engineering tool to the CPU module, and set the parameters as follows.
Set the same parameters to FDL address 1 and FDL address 3.
For setting DP-Slaves that use the module other than the RJ71PB91V, refer to the manual for the module used.
Creating a new project
1.
Set the CPU module, and add the module labels of the CPU module. The procedures for setting the CPU module and for
adding the module labels are the same as those for the DP-Master. ( Page 37 Settings for DP-Master)
2.
Set the RJ71PB91V(S) as follows.
[Navigation window]  [Parameter]  [Module Information]  Right-click  [Add New Module]
3.
Set the items in "Basic Setting" as follows. For FDL address 1, set "1" to "FDL Address Setting". For FDL address 3, set
"3" to "FDL Address Setting".
[Navigation window]  [Parameter]  [Module Information]  [RJ71PB91V(S)]  [Basic Setting]
7 COMMUNICATION EXAMPLE
7.1 Communication example of I/O data exchanges
7
43