Canon LBP253 SM Manual page 58

Setting information can be exported by remote control by following the procedure shown below.
Since the information can be output only to a USB flash drive connected to the host machine, this is not strictly remote
operation.
The following USB flash drives can be used for export/import.
• USB flash drive in FAT 16 format (storage capacity: 2 GB)
• USB flash drive in FAT 32 format (storage capacity: 32 GB)
1. Connect a USB memory device to the USB memory port.
Connect the USB memory of Operation Panel. The USB port on the rear side of the host machine cannot be used.
2. Enter service mode, and execute the following service mode.
Access service mode (Remote UI), select COPIER > FUNCTION > SYSTEM > EXPORT, and click [EXEC].
CAUTION:
When it is executed without connecting USB flash drive, the error message is not displayed.
Processing doesn't export anywhere of any though it seems to have completed it correctly.
Confirm USB memory device has been connected before it executes it from the above-mentioned reason without fail.
3. The message shown below which is displayed during the process will disappear. When the display has returned to
the original state, remove the USB flash drive.
4. Check that a setting information file (service.dcm) exists in the directory directly under the root of the USB flash
drive.
This completes the procedure for exporting a setting information file.
● Procedure for Import Using Service Mode
1. To the directory directly under the root of the USB flash drive, save a setting information file (service.dcm) to be
imported.
2. Connect a USB memory device to the USB memory port.
51
2. Technology