Compressor-Type Air Conditioner; Noise Level; Hydraulic Accumulators - Claas DOMINATOR 208 MEGA III Operator's Manual

7. Before mounting or entering the grain tank,
make sure that the drive is disengaged and that
the engine has been stopped. Ensure that no
other person can restart the engine.
8. When travelling on public roads and lanes, the
finger bar and/or crop lifters must be covered
when carrying the cutterbar.

Compressor-type air conditioner

1. The air conditioning system is filled with HFC
refrigerant R 134A. HFC refrigerants must not
be vented to the atmosphere. – Therefore,
please take appropriate precautions when
working on the compressor-type air conditioner.
2. Maintenance and repairs are only to be carried
out by authorized service centres qualified to
handle refrigerants. Refrigerants must always
be discharged by use of the correct recovery
equipment and disposed of for recycling.
Service
1. Repair, service and cleaning work and the
elimination of malfunctions should only be per-
formed with the drive and engine switched off.
Remove the main switch key (ignition key)!
2. Escaping fluid (fuel or hydraulic oil) under high
pressure can penetrate the skin and cause
serious injury. If any fluid is injected into the
skin, consult a doctor immediately as otherwise
serious infections may result!
3. Be careful when opening the radiator filler cap.
As long as the engine is hot, the radiator is
under pressure.
4. Dispose of oil, fuel and filters in a way that is
harmless to the environment and in accordance
with existing anti-pollution regulations.
5. Do not attempt to mount a tyre unless you
have the proper equipment and experience to
perform the job safely.
6. Retighten the wheel nuts and wheel bolts
regularly.
7. Only have qualified workshops carry out repair
work on the hydraulic system.
Basic rule
Always check the operating and road safety of the
combine before starting the machine.

Noise level

The noise level at the ear of the driver in the cab
with doors and windows closed is 82 db (A).
298 672.0 - BA DO 208 / 204 MEGA

Hydraulic accumulators

Take particular care when working on hydraulic
accumulators! Hydraulic accumulators are under
high pressure!
In the case of valve-controlled accumulators such
as for the Autopilot, the short-circuit screw has to be
loosened before starting repair work on the accumu-
lator so that the hydraulic pressure is relieved.
Safety rules
4.1.3