Advertisement
How can I change the door open time? - Enter programming mode and hold down "5" for 3
seconds. Enter the time required door open time, in seconds between 1 and 60 e.g. for 5 seconds
type in "0" then "5" . The default value is 7 seconds.
How can I stop the keypad from beeping? - The keypad can be made to work in silence if, for
example, it is located near to where someone is working. Enter the programming code and hold
down "3" for 3 seconds. Press the "6" button and the keypad will no longer beep when keys are
pressed.
How can I use the remote button wires? - The remote button wires can be used as either a
standard exit button, where the door opens for the door open time following a button press, or
as a toggle device where the remote button will toggle the door open until it is pressed again
or a toggle code is entered on the keypad. Enter the programming code and hold down "7" for 3
seconds. Press the "6" button to set the button to toggle the lock.
How can I stop people trying to guess the entry code? - Lockout is a function where the keypad
will lock to prevent someone from continually trying to guess the entry code. After 20 incorrect
keys have been pressed the keypad will lock out for a period of 1 minute. To activate lockout, enter
programming mode and hold down "4" for 3 seconds then press "6" .
How can I make the keypad work with a fail open lock? - As default the keypad only powers the
lock during the door open time. To reverse this operation, first enter programming mode, hold
down "1" for 3 seconds. Press the "6" button. The lock wires will now operate for fail open locks.
What can I do if it all goes wrong? - The keypad can be reset back to factory defaults with the
exception of the programming code. Enter programming mode and hold down "9" for 3 seconds.
Re-enter the programming code and hold down "9" for a further 3 seconds. The keypad will now
be reset. If the master code becomes lost a hardware reset must be performed. To do this turn off
the power to the unit, hold down the '3' button on the keypad and re-administer power to the unit.
When the power is applied, release button '3' . Three beeps will indicate that the unit has successfully
data reset.
What is the Hardware Reset Procedure? - If the master code becomes lost a hardware reset must
be performed. To do this turn off the power to the unit, hold down the '3' button on the keypad
and re-administer power to the unit. When the power is applied, release button '3' . Three beeps will
indicate that the unit has successfully data reset.
AN1003 - How to program a TOUCHLOCK compact
Compact
2
Advertisement
