Cisco UCS C220 M5 Maintaining page 57

Maintaining the Server
Note Riser 2/Slot 2 is not available in single-CPU configurations.
Replacing a PCIe Card
Note
If you are installing a Cisco UCS Virtual Interface Card, there are prerequisite considerations. See
Virtual Interface Card (VIC) Considerations, on page
Note
RAID controller cards install into a separate mRAID riser. See
(RAID or HBA) in Riser 3, on page
Step 1 Remove an existing PCIe card (or a blank filler panel) from the PCIe riser:
a) Shut down and remove power from the server as described in
on page 7.
b) Slide the server out the front of the rack far enough so that you can remove the top cover. You might have to detach
cables from the rear panel to provide clearance.
If you cannot safely view and access the component, remove the server from the rack.
Caution
c) Remove the top cover from the server as described in
d) Remove any cables from the ports of the PCIe card that you are replacing.
e) Use two hands to grasp the external riser handle and the blue area at the front of the riser.
f) Lift straight up to disengage the riser's connectors from the two sockets on the motherboard. Set the riser upside-down
on an antistatic surface.
g) Open the hinged plastic retainer that secures the rear-panel tab of the card.
h) Pull evenly on both ends of the PCIe card to remove it from the socket on the PCIe riser.
If the riser has no card, remove the blanking panel from the rear opening of the riser.
Step 2 Install a new PCIe card:
a) With the hinged tab retainer open, align the new PCIe card with the empty socket on the PCIe riser.
PCIe riser 1/slot 1 has a long-card guide at the front end of the riser. Use the slot in the long-card guide to help support
a full-length card.
b) Push down evenly on both ends of the card until it is fully seated in the socket.
c) Ensure that the card's rear panel tab sits flat against the riser rear-panel opening and then close the hinged tab retainer
over the card's rear-panel tab.
59.
Replacing a SAS Storage Controller Card
63.
Shutting Down and Removing Power From the Server,
Removing the Server Top Cover, on page
Replacing a PCIe Card
Cisco
9.
Maintaining the Server
57