Adjust Plunger Screw; Test Operation - Assa Abloy Corbin Russwin ED7800 Series Installation Instructions Manual

Concealed vertical rod, exit devices

Hide thumbs Also See for Corbin Russwin ED7800 Series:

Table of Contents

ED7800 Series

Concealed Vertical Rod Exit Devices

Installation Instructions

Adjust Plunger Screw

When door is closed against top strike,

plunger screw releases top latch and

bottom bolt. Adjust so that when door is

shut tight, screw head just touches strike.

(Figure 20)

From Outside: When door is opened by turning operator latch, top latch and bottom bolt should

retract and stay retracted until plunger screw is pushed in.

From Inside: When door is opened by depressing crossbar, top latch and bottom bolts should retract,

and stay retracted until plunger screw is pushed in.

Lock crossbar in dogged down position. Latch and bolt should be fully retracted.

NOTE: No dogging feature on "U" series.

For installation assistance contact Corbin Russwin

1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com

in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.

Just Touch

Figure 20

FM466 04/20

Table of Contents

Do you have a question about the Corbin Russwin ED7800 Series and is the answer not in the manual?