Table of Contents
Advertisement
ED7800 Series
Concealed Vertical Rod Exit Devices
Installation Instructions
2
Pre-Installation
Important
4061, 4062, 4063, 4068, CH641, CH642, CH643, CH648 "U" indicates UL Listed and "MR" indicates
Master Ring Cylinder.
Before installing, check position of parts
for hand of door and reverse hand of
fixture if necessary.
1. To change to opposite hand,
2. Remove case covers by removing
3. Switch case covers and
3
Prepare Door and Frame
If not already fully prepared, follow template furnished and drawings shown for exposed screw or hidden
(bracket) mounting. See Figure 6 on page 5.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2018, 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
hammer pin to opposite side of
flange.
(Figure 3)
top and bottom screw at back of
each case.
reassemble.
a. Place cover from present active
case (A) on inactive case,
engaging lifting finger with
bottom of slide.
(Figure 4)
b. Place cover from inactive case
(B) on active case, engaging
lifting finger with bottom of
slide. Be sure that nylon button
on back of cover fits into hole
in plate. (Figure 5)
NOTE: Be sure that plate with
hole in it is positioned in active
case with rounded end down.
Flush
LHRB
Flush
RHRB
Plate
Active
Inactive
Cover A
Case
Case
Lift
Inactive
Case and
Cover A
4
Figure 3
Figure 4
Cover B
Active
Case and
Cover B
Figure 5
FM466 04/20
Advertisement
Table of Contents
