On Works - IDEC LonWorks FC3A-SX5LS1 User Manual

L W I
ON ORKS NTERFACE
Function Area Setting for L
The quantity of transmit/receive data for L
in WindLDR . The OpenNet Controller
and analog I/O modules, automatically at power-up and exchanges data with L
allocated to each node.
Since these settings relate to the user program, the user program must be downloaded to the
changing any of these settings.
Programming WindLDR
1. From the
WindLDR
appears.
2. Select the Open Bus tab.
Configure Communication
Master Module Check Box
Check this box only when
the remote I/O master
module is used.
Slave Station
Transmit/Receive
Data Quantity (Bytes)
When using OpenNet inter-
face modules for DeviceNet,
INTERBUS, or L W
ON ORKS
specify the data bytes to
communicate through each
OpenNet interface module.
3. Select transmit and receive data bytes for module position 1 through 7 where the L
mounted.
4. Click the OK button and download the user program to the
10
M
ODULE
W
ON ORKS
W
ON ORKS
CPU module recognizes all functional modules, such as OpenNet interface modules
menu bar, select Configure > Function Area Settings. The Function Area Setting dialog box
,
O N C
PEN ET ONTROLLER
Node
network communication is specified using the Function Area Setting
OpenNet Controller
L W I M
ON ORKS NTERFACE ODULE
W nodes through the link registers
ON ORKS
OpenNet Controller
Quantity of Nodes Connected
When using the remote I/O mas-
ter module, specify the quantity
of nodes from 1 through 32.
Transmit/Receive Bytes 0 to 8
(default: 8 bytes)
This value determines the data
quantity 0 through 8 bytes (64
bits) to communicate with the
network.
For the example on the next
page, select 8 transmit bytes and
4 receive bytes for Module 1.
W interface module is
ON ORKS
.
U ' M
SER S ANUAL
after