Control Board Replacement - Bradford White EF100T150(E)*(N Service Manual

Control Board Replacement

Step 1. Position main power switch to "OFF"
Step 2. Disconnect (unplug) water heater from 120
volt power source.
Step 3. Un-latch and remove top surround cover
from top of water heater.
Step 4. Locate control board.
Step 5. Carefully disconnect all wire
connections from control board.
Note: It may be necessary to
identify wires for
proper re-connection.
Step 6. Depress the plastic tabs on the blower side of the
control board first.
Step 7. Tilt the control panel and slide control hook tabs from
slots in the control panel (see photo at right).
Step 8. Replace control board and all wire connections.
Step 9. Restore 120 volt power supply to water
heater and confirm proper operation following
the lighting instructions on the lighting
instruction label or the lighting instruction
located in the installation and operating
instruction manual.
Step 10. Replace surround cover on top of water heater.
(Honeywell Integrated Control w/ Direct Spark Ignition)
120 volt potential exposure. Isolate the
disconnected using a multi-meter.
Control Board
Unclip this
side second
WARNING
appliance and reconfirm power is
Unclip blower
Blower
side first
67
67