To Display Flame Sense Current of the Pilot Flame Sensor:
The pilot flame sense current is available only when the burners are in operation. Step 1: Make sure the status displays
"Heating" or draw enough hot water to start the burners. Step 2: Enter the "Service Mode" described previously. Step 3:
Press the "Select" button until a number value is displayed with "Flame Current" to the right of the number. The value
displayed is in microamps (µA).
To Display and Change Temperature Setpoint:
Step 1: In "Service Mode" press the "Select" button until "Setpoint" is shown in the water heater display
26
Accessing Service Mode on Control Display
For models with Honeywell Integrated Control
Flame
Current
µA
Heating
Status Operational
SELECT
SET
setpoint
°F
idle
Status
Operational
SELECT
SET
26