Honeywell Performance Series User Manual page 5

Cautions and Warnings
CAUTION
Certified/UL Listed Class 2 power adapters are required.
CAUTION
employed when powering on the camera from 24 V AC.
CAUTION
CAUTION
qualified and experienced technicians to conform to all local codes and to
maintain your warranty.
Regulatory Statements
FCC Compliance Statement
Information to the User: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
•
•
•
To ensure compliance with electrical safety standards, CSA
To comply with EN50130-4 requirements, a UPS should be
When installing the camera, cables must not be left bare.
Installation and servicing should be performed only by
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
| 5
800-23288 - A - 07/2017