Table of Contents
Advertisement
If possible, store the pump under a roof to protect it against the weather. In areas, where it gets frosty during the
winter, empty the pump housing by removing the plugs at the lowest part of the pump housing.
ATTENTION!
Observe the local laws and regulations when disposing of pumps and pump parts as a result of repair and
maintenance works or putting out of operation. This is especially valid for the treatment of medium remains in
the pump body.
12 TECHNICAL DATA
Model
Input speed
Motor power output
Discharge capacity
Manometric head
Required minimum pit opening
Oil filling volume gear box
Oill filling volume drive pipe SAE 20
Liter
The technical data, pcitures and measurements are not binding. They cannot be the basis for claims. We
reserve the right to modify the equipment without making corrections to the present instruction manual
Operating Manual for BAUER Long Shaft Pump
Important to observe:
Keep stones, iron and wooden pieces, binder twine, plastic bags etc. away from the
slurry pit.
Before doing work around the cutting knives, it is important to stop the tractor (LP)
and disconnect the PTO shaft and the power supply (LE).
Oil leaking during the standstill of the pump between the bearing body and the knife
hub shows that the sealing of the drive shaft at the lower bearing is worn-out and
must be replaced immediately. Otherwise there will be severe and costly damages
to the pump.
1/min
KW
m³/h
40 – 360
m
m
SAE 90
Liter
betw. 8 l at 2 m
LP 55
LE 11
Max 640
40
11
40 – 240
28,5 – 9
17 – 4
2
and
LE 15
1450
15
18,5
40 – 270
40 – 300
20 – 6
22 - 7
0,6 x 0,8
N/A
13 l at 5 m (length of the model)
LE 18,5
17
Advertisement
Table of Contents
