Pumps - Bauer Magnum LP Series Operating Manual

10 Pumps

When the pit content is stirred evenly, the delivery can start. To do this, the delivery/pressure line has to be
connected.
Warning: The pump can only be lifted or lowered with the cable winch while the PTO shaft is at a standstill.
To pump, press the lever for the rotating valve down and fix with the tommy screw.
Warning: After coupling the tractor PTO shaft, only gradually increase the speed of rotation so that the pressure
line does not pressure hammer because of the sudden pressure.
While distributing the slurry, under normal conditions, it is only necessary to briefly mix every 3 hours.
Operating Manual for BAUER Long Shaft Pump
If tractor-driven
Connect with the PTO shaft. The overload protection has to be on
the tractor side.
Warning: Cutting to length, section pipe over-lapping, and
maintenance see separate instructions for PTO
of the PTO shaft shall not be more than 30 ° .
The stirring device has three levers.
The function of the lever in the middle is to horizontally swivel the
pressure line including the stirring nozzle.
The lever to the left of it has the function to vertically swivel the
stirring nozzle.
The lever to the right of it has the function to switch the three-way
cock from mixing (lever up) to pumping (lever down) or both.
The position of the levers can be set with the clamping bolts.
shaft.
Lower the pump until the stirring
nozzle dives into the floating layer.
By repeatedly swivelling the stirring
nozzle hence and forth, the time to
homogenize the pit content can be
reduced essentially.
The bending
15