Table of Contents
Advertisement
Electronics
3-9 Building an Array of AC modules
•
Remove the tape securing the AC cables and connectors to the back of the module.
•
Each AC module has an AC cable male connector and an AC cable female connector.
•
AC cable female connector is located on the left at rear side, or the right at front side.
•
AC cable male connector is placed on the right at rear side, or left at front side.
•
For easy recognition of the position, the
for the location of the male connector.
•
Because male connector is designed to be connected with a female connector or female end cap, there is a need to
keep track of the positions of male and female connectors when you build an array.
•
The AC module produced by LG Electronics is delivered with the microinverter pre-installed on the DC module.
•
Therefore, it eliminates installation steps for pairing DC module outputs and microinverter inputs.
•
The length of the AC cables are designed to enable easy cable links throughout an array you have designed.
•
Landscape, portrait or a combination of both is possible with the AC cable connectors.
•
Even if there are roof vents on the target site, AC cable connection is feasible for the AC module array to circumvent
the vent area.
Male
AC Cable Female Connector
End Cap
F
Position of the female connector
The end caps are not attached on the above AC cable connectors. Male or female end caps are
provided with extension cables. This diagram is for showing that each end cap has its pair.
Rev. 1.0
AC Module System Installation Manual
below represents the location of the female connector and the
F
Copyright © 2020 LG Electronics.
All Rights Reserved.
M
AC Cable Male Connector
M
Position of the male connector
stands
Female
End Cap
24
Advertisement
Table of Contents
