Toyota 1RZ Supplement Manual page 521

CLICK HERE TO VIEW CHAPTER INDEX
CH- -14
45A 55A
70A
29 mm
Socket
Wrench
SST (A)
SST (B)
SST (C)
CHARGING
RE AS S E M BLY
1 .
2 .
P14543
3.
(a)
A01826
(b)
(c)
(d)
P14472
4 .
(a)
(b)
Turn
(c)
P04209
(d)
(e)
P04210
- - ALTERNATOR
P L ACE DRI V E E ND F RAME O N P ULLE Y
I NS TALL RO TO R TO DRI V E E ND F RAME
INSTALL RECTIFIER END FRAME
Place the alternator washer on the rotor.
Using a 29 mm socket wrench and press, slowly press in
the rectifier end frame.
55A:, 70A:
Install the 4 nuts.
Torque: 4.5 N∙m (46 kgf∙cm, 40 in.∙lbf)
45A:
Install the 2 nut and 2 bolts.
Torque: 4.5 N∙m (46 kgf∙cm, 40 in.∙lbf)
I NS TALL P ULLE Y
Install the pulley to the rotor shaft by tightening the pulley
nut by hand.
Hold SST (A) with a torque wrench, and tighten SST (B)
clockwise to the specified torque.
SST 09820 -- 63010
Torque:39 N∙m (400 kgf∙cm, 29 ft∙lbf)
Check that SST (A) is secured to the pulley shaft.
Mount SST (C) in a vise.
Install SST (B) into (C), and attach the pulley nut to SST
(C).
3RZ-F,3RZ-FE Pages From Supplement
TO MODEL INDEX
CONTINUED
CH038- -01