Battery Saver On/Battery Saver Mode; Actions - If Equipped - Dodge DURANGO 2021 Owner's Manual

96 GETTING TO KNOW YOUR INSTRUMENT PANEL
Trip A

Trip B

Trailer Trip

Gain

Upper Right
None

Compass

Outside Temp

Time

Range To Empty (RTE)

Fuel Economy Average

Fuel Economy Current

Trip A

Trip B

Trailer Trip

Gain

Defaults (Restores All Settings To Default
Settings)
Restore

Cancel

Speed Warning — If Equipped
Push and release the up or down
button until the Speed Warning Menu icon/title
is highlighted in the instrument cluster display.
Push and release the OK button to enter speed
warning. Use the up or down
to select a desired speed, then push and
release the OK button to set the speed. When
the set speed is exceeded, the indication will
light up yellow and flash along with a pop up
message of "Speed Warning Exceeded" with a
continuous chime (until the speed is no longer
exceeded).
B S O /B
ATTERY AVER N ATTERY
M M — E
ODE ESSAGE LECTRICAL
R A — I
EDUCTION CTIONS F
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional
monitoring of the electrical system and status
of the vehicle battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions will
take place to extend the driving time and distance of
the vehicle. This is done by reducing power to or
turning off non-essential electrical loads.
Load reduction is only active when the engine is
arrow
running. It will display a message if there is a
risk of battery depletion to the point where the
vehicle may stall due to lack of electrical supply,
or will not restart after the current drive cycle.
arrow button
When load reduction is activated, the message
"Battery Saver On" or "Battery Saver Mode" will
appear in the instrument cluster.
These messages indicate the vehicle battery
has a low state of charge and continues to lose
electrical charge at a rate that the charging
system cannot sustain.
S
NOTE:
AVER
L
OAD
The charging system is independent from

E
QUIPPED
load reduction. The charging system
performs a diagnostic on the charging
system continuously.