Table of Contents
Advertisement
• Down Arrow Button
Push and release the down arrow button to
scroll downward through the main menus and
submenus.
• Right Arrow Button
Push and release the right arrow button for
access to main menus or submenus. Push and
hold the right arrow button for two seconds to
reset features.
• BACK Button
Push and release the BACK button to scroll back
to a previous menu.
Oil Change Due
Your vehicle is equipped with an engine oil
change indicator system. The "Oil Change Due"
message will appear in the instrument cluster
display for five seconds after a single chime has
sounded to indicate the next scheduled oil
change interval. The engine oil change indicator
system is duty cycle based, which means the
engine oil change interval may fluctuate depen-
dent upon your personal driving style.
58
Unless reset, this message will continue to dis-
play each time you cycle the ignition to the
ON/RUN position. To turn off the message tem-
porarily, push and release the up arrow button.
To reset the oil change indicator system (after
performing the scheduled maintenance), per-
form the following procedure:
1. Without pushing the brake pedal, push and
release the ENGINE START/STOP button
and cycle the ignition to the ON/RUN posi-
tion (do not start the engine).
2. Fully push the accelerator pedal, slowly,
three times within 10 seconds.
3. Without pushing the brake pedal, push and
release the ENGINE START/STOP button
once to return the ignition to the OFF/LOCK
position.
NOTE:
If the indicator message illuminates when you
start the vehicle, the oil change indicator sys-
tem did not reset. If necessary, repeat this
procedure.
Instrument Cluster Display Selectable
Menu Items
Push and release the up or down arrow button
until the desired Selectable Menu item is dis-
played in the instrument cluster display.
Follow the Menu or submenu prompts as de-
sired.
Refer to "Instrument Cluster Display" in "Get-
ting To Know Your Instrument Panel" in the
Owner's Manual for further information.
Battery Saver On/Battery Saver Mode
Message — Electrical Load Reduction
Actions — If Equipped
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional
monitoring of the electrical system and status of
the vehicle battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions
will take place to extend the driving time and
distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical
loads.
Advertisement
Table of Contents
