Ignition Switch; Keyless Enter 'N Go - Ignition - Dodge DURANGO 2021 Owner's Manual

In addition, if the light begins to flash after the
bulb check, it indicates that someone used an
invalid key fob to start the engine. Either of
these conditions will result in the engine being
shut off after two seconds.
If the Vehicle Security Light turns on during
normal vehicle operation (vehicle running for
longer than 10 seconds), it indicates that there
is a fault in the electronics. Should this occur,
have the vehicle serviced as soon as possible by
an authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
All of the key fobs provided with your new
vehicle have been programmed to the vehicle
electronics Ú page 357.

IGNITION SWITCH

K E ' G — I
EYLESS NTER N O GNITION
This feature allows the driver to operate the
ignition switch with the push of a button as long
as the key fob is in the passenger compartment.
The START/STOP ignition button has several
operating modes that are labeled and will
illuminate when in position. These modes are
OFF, ACC, ON/RUN, and START.
START/STOP Ignition Button
1 — OFF
2 — ACC
3 — ON/RUN
GETTING TO KNOW YOUR VEHICLE
The push button ignition can be placed in the
following modes:
OFF
The engine is stopped

Some electrical devices (e.g. central locking,

alarm, etc.) are still available
ACC
Engine is not started

Some electrical devices are available

(e.g. power windows)
ON/RUN
Driving position

All the electrical devices are available

(e.g. climate controls, etc.)
START
The engine will start (when foot is on the

brake pedal)
17
2