Toshiba RAV-GM1601ATP-E (TR) Service Manual page 98

No. Part name
Compressor
6
and
When removing the welding part of the suction /
Compressor
discharge pipe of the compressor, remove
lead
them after recovering the refrigerant in a well-
ventilated place. If recovery is insufficient the
refrigerant and refrigerating machine oil may
squirt, cause injury.
1. Remove broken compressor
1) Recover refrigerant gas.
2) Following to work of Detachment 1 , 2
3) Remove the piping panel (front).
4) Remove screws of the piping panel (rear)
and base plate (Ø4 × 10, 2 pcs.).
5) Remove the valve fixing plate
6) Remove the valve fixing plate and the
partition plate (Ø4 × 10, 1 pcs.)
7) Remove the sound insulation board
(Upper, Inner and Outer).
8) Remove TD sensor from discharge pipe.
9) Remove terminal cover of compressor
(2 Claws), compressor lead and compressor
case thermostat (1 Claw).
10) Remove the compressor lead from
partition plate.
11) Remove the discharge and suction pipes
connected to the compressor using a burner.
Procedure
WARNING
3 and 4
3.1) Remove screws of the piping panel
(front) and base plate (Ø4 × 10, 2 pcs.).
3.2) Remove screws of the piping panel
(front) and the piping plate (rear)
(Ø4 × 10, 1 pcs.).
5.1) Remove bolt for liquid valve side and
valve fixing plate (M6 x 15, 2 pcs.).
5.2) Remove bolt for gas valve side and
valve fixing plate (M6 x 15, 2 pcs.).
TD sensor
Sound
insulation
(Upper)
Sound
insulation
(Outer)
Piping
panel
(Front)
Valve fixing plate
Sound insulation (Upper)
Sound insulation (Outer)
- 98 -
Remarks
Partition plate
Liquid valve side
Screw M6
Gas valve side
TD sensor
Terminal
cover of
compressor
Sound insulation (Inner)
Piping
panel
(Rear)