Toshiba RAV-GM1601ATP-E (TR) Service Manual page 96

No. Part name
1. Detachment
Side cabinet
4
(right)
1) Following to work of Detachment of 1 .
2) Remove the screws from the side panel (right)
3) Remove the screws from the side panel (right)
4) Remove the screws from the side panel (right)
5) Remove the screws from the side panel (right)
6) Remove the screws from the side panel (right)
7) Slide the side cabinet (right) upward and then
2. Attachment
Attachment the side cabinet (right) in the
reverse process of "1.Detachment".
1. Detachment
Fan motor
5
1) Following to work of Detachment of 1 , 2
2) Make sure that the fan motor and the propeller
3) Remove flange nut from the fan motor and
4) Remove propeller fan.
5) Remove inverter box cover from inverter box
6) Remove the connector of fan motor from the
7) Remove fan motor lead from the fan motor
8)
9)
10) Cut the binding band at base motor.
11) Loose the 3 claws (Each motor) on the base
12) Remove the fixing screws (4 Positions / each)
Procedure
and the inverter box. (Ø4 × 10, 2 pcs.)
and the valve fixing plate, (Ø4 × 10, 2 pcs.)
and the piping panel (rear), (Ø4 × 10, 2 pcs.)
and the base plate, (Ø4 × 8, 2 pcs.)
and the heat exchanger, (Ø4 × 8, 3 pcs.)
remove it from hook of Inverter box.
and 3
fan stop.
propeller fan.
(Ø4 × 8, 1 pcs.)
inverter box.
lead fixing rubber at the partition plate.
For fan motor lead (Upper), Cut the white
binding band 1 pcs. and remove fan motor
lead from core clamp on Inverter box.
For fan motor lead (Lower), Remove them
from Cable clamp 2 position.
motor.
while holding the fan motor so as not to fall it.
Inverter
box
Valve
fixing
plate
Propeller fan
Flange nut
Screw
Connector of fan motor (Upper)
- 96 -
Remarks
Side cabinet (Right)
Piping panel (Rear)
Loosened by
turning clockwise
Cover inverter
Connector of fan motor (Lower)