Assa Abloy Corbin Russwin EcoFlex NAC Series Installation And Wiring Instructions page 7

EcoFlex Electrified Mortise Locks (NAC-)
™
with High-Security Monitoring Options
Installation and Wiring Instructions
3. Handing of Lock Body
1. Move the red locking screw to side of
lock body being locked (Fig. 1)
2. Push in latch then depress catch plate
with screw driver (Fig. 1)
3. Pull latch out of lock body and
turn latch over (Fig. 2)
Figure 2
Step 4) Push in latch while holding
screw driver behind latch tail (Fig. 3)
Note: Push in latch until catch plate is
no longer depressed (Fig. 4)
Step 5) Rotate lock front to match
bevel of door as shown (Fig. 5)
Figure 5
6) Installation Instructions (Continued)
RED Locking Screw
7
MAKE SURE CATCH PLATE IS
EVEN W/TOP SURFACE
GOOD
Figure 4
WARNING: LOCK-
IN CAN OCCUR
IF LATCH IS NOT
PROPERLY IN-
Figure 3
STALLED
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express
written permission of ASSA ABLOY Access and Egress Hardware Group, Inc.
is prohibited.
Catch Plate
Figure 1
BAD