Advertisement
8. Check that the media path through the printer is straight. The media should be centered under
the Print Head.
Locking Screw
9. Lower the Print Head Block until it stops.
Batch mode
In the batch mode, the media is continuously printed and fed until the numbers of labels/tags
specified in the issue command have been printed.
Loading with peel off module
When the optional Peel-off Module is fitted, the backing paper is automatically removed from the
label at the Strip Plate as each label is printed.
(1) Remove enough labels from the leading edge of the media to leave 500mm of backing paper
free.
(2) Insert the backing paper under the Strip Plate.
(3) Wind the backing paper onto the Take-up Spool and fix it in position with the Take-up Clip.
(Wind the paper counterclockwise around the spool as this is the direction it rotates.)
(4) Rotate the Take-up Spool counter-clockwise a few times to remove any slack in the backing
paper.
(5) Set the Selection Switch mounted on the Rewinder Assembly to STANDARD/PEEL OFF
position.
Strip Plate
Media Guide
Media
Backing Paper
E-5
Print Head
Media Guide
Take-up Spool
Take-up Clip
Paper Guide
Advertisement
