Advertisement
NOTES:
1. When the Head Lever is turned to FREE position, the Print Head is raised.
2. To enable printing the Head Lever must be set to the LABEL / TAG position. (This ensures that the
Print Head is closed.)
There are two head pressure levels in the LABEL / TAG position. Set the Head Lever depending on the
media type:
Position LABEL: Labels
Position TAG:
Tags
However, proper position may differ depending on media. For details, refer to your TOSHIBA TEC
authorised service representative.
3. Push the Paper guide R to the right or in horizontal movement.
4. Put the media on the Paper Holder.
5. Pass the media around the Paper Holder, and then pull the media towards the front of the
printer.
6. Push the Paper Guide against the media until the media is held firmly in place. To lock the
Media, shift the Paper Guide R to vertical position.
In the case of labels rolled with
the print side facing inside.
7. Place the media between the Media Guides, adjust the Media Guides to the media width, and
shift the Paper Guide R to vertical position to tighten.
Paper Guide L
In the case of labels rolled with
the print side facing outside.
E-4
Paper Guide R
Advertisement
