Fujitsu AS G07KGTA Series Service Instruction page 55

Trouble shooting 28
OUTDOOR UNIT Error Method:
4-Way Valve Error
Detective Actuators:
Indoor unit Controller PCB
Heat Ex. temperature thermistor
Room temperature thermistor
4-way valve
Forecast of Cause :
1. Connector connection failure
5. Controller PCB failure
Check Point 1 : Check connection of Connector
Check if connector is removed.
Check erroneous connection.
Check if thermistor cable is open.
>> Upon correcting the removed connector or mis-wiring, reset the power.
OK OK
Check Point 2 : Check each thermistor
Isn't it fallen off the holder?
Is there a cable pinched?
>> Check characteristics of thermistor (Refer to Trouble shooting14,15),
If defective, replace the thermistor
OK OK
Check Point 3 : Check the solenoid coil and 4-way valve
[ Solenoid coil ]
Remove P60 from PCB and check the resistance value of coil.
Resistance value is 1.88k
>> If it is Open or abnormal resistance value, replace Solenoid Coil.
[ 4-way valve ]
Check each piping temperature,
and the location of the valve by the temperature difference.
>> If the value location is not proper, replace 4-way valve.
OK OK
Check Point 4 : Replace Controller PCB
If Check Point 1- 3 do not improve the symptom, replace Controller PCB.
Indicate or Display:
Outdoor Unit : No indication
Indoor Unit
ERROR CODE : [E : 99 ]
Detective details:
When the indoor heat exchanger temperature is compared with
the room temperature, and either following condition is detected
continuously two times, the compressor stops.
Cooling or Dry operation
[Indoor heat exchanger temp.] - [Room temp.] > 10degC
Heating operation
[Indoor heat exchanger temp.] - [room temp.] < - 10degC
If the same operation is repeated 5 times,
the compressor stops permanently.
2. Thermistor failure
2.29k (at 20°C).
: Operation lamp: 9 time Flash, Timer lamp: 9 time Flash
Economy lamp: Continuous flash.
3. Coil failure
02-29
4. 4-way valve failure