Operation Modes And Keypad Operations; Operation Modes; Keypad Operations - PCE Health and Fitness PCE-ORP 3 Operation Manual

OPERATION MODES AND KEYPAD OPERATIONS

A. Operation Modes
. PCE-ORP 3 meter has 7 operation modes:
1. Measure Mode.--Measure Mode is used to make all absolute or
relative ORP and temperature measurements.
2. Calibration Mode.--Calibration Mode is used to perform offset
voltage adjust.
3. Hold Mode.--Hold Mode is used to display held measured values
for increased ease of use.
4. Recall Data Mode.--Recall Data mode is used to display
measured data which have been stored in memory.
5. Store mode.--Can save up to 50 set data in non- volatile memory.
6. Date and Time Set Mode.--Date and Time Set Mode is used to
change date and time.
7. Erase Mode.--Can erase 50 set data in non- volatile memory.
B. Keypad Operations
Operation
Key
Mode
All, except Hold
Measure
HOLD
Hold
Date and Time
Set
Calibration
Measure
Measure
MODE
Calibration
Date and Time
Set
Measure
STORE
Calibration
Duration Function
2 seconds or
Turns meter on/off.
more
Holds current measurement
0 second reading. Press again to
resume measuring.
0 second Returns to Measure Mode.
Moves cursor to next set of
0 second
data.
Moves cursor to next digit
0 second
or sign.
2 seconds Enters Calibration Mode.
10 seconds or Enters Date and Time Set
more Mode.
0 seconds Increases current number.
0 seconds Increases current number.
Stores
current absolute & relative
2 seconds
ORP reading, date and
time into memory.
2 seconds or
Leaves Calibration Mode.
more
4
Temperature,