Replacement Parts - Jet JJ-6HHBT Operating Instructions And Parts Manual

Troubleshooting
Trouble
Motor does not start.
Motor starts slowly or
fails to come to full
speed.
Motor running too hot
Snipe (gouging at end
of boards)

13.0 Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and
Serial Number of your machine available when you call will allow us to serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from
Powermatic. Some parts are shown for reference only, and may not be available individually.
Probable Cause
Low line voltage
Defective switch
Motor failure.
Defective motor windings.
Clogged with wood chips
Motor overloaded
Restricted air circulation due to dust
accumulation
Dull knife inserts
Inadequate support of long boards
Uneven feed
Remedy
Correct low line voltage
Have switch replaced
Have motor repaired or replaced
Have motor repaired or replaced.
Take shallow depth of cut and attach
a shop-vac to exhaust port. Inspect
chip blower assembly and fan belt
Reduce load on motor
Clean dust and restore normal air
circulation
Rotate or replace inserts.
Support long boards with roller stand
or an assistant.
Feed workpiece evenly and smoothly.
15