Operation; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL 43.106.25 Operating Instructions Manual

and fitted correctly, because, e.g. they may
already be provided on the bench-type circu-
lar saw.

6. Operation

Accessory slide used as an angle stop/cross
stop (Fig. 11)
•
The slide can be used as an angle stop/cross
stop in the same way as the universal stop.
•
Slacken the clamping lever (104).
•
Turn the stop rail (101) until the arrow points
to the angle required. 0° for use as a cross
stop (90° cuts) – a different angle for angle
cuts.
•
Re-tighten the locking grip (104).
•
Note! Do not push the stop rail too far toward
the blade. The distance between the stop rail
and the blade should be approx. 2 cm.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_Schiebeschlitten_SPK7.indb 15 Anl_Schiebeschlitten_SPK7.indb 15
GB
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and
30°C. Store the electric tool in its original pa-
ckaging.
The reprinting or reproduction by any other me-
ans, in whole or in part, of documentation and
papers accompanying products is permitted only
with the express consent of the iSC GmbH.
Subject to technical changes
- 15 -
29.04.14 17:06 29.04.14 17:06