Can-Io Module Connections; Connectors, Signals And Configuration Element; Power - gefran CAN-IO Installation And User Manual

CAN-IO module connections

Connectors, signals and configuration element

N� Description
1

Power

2 Run
3 Power input 24 Vdc ± 25%
4 CAN Port
5 CAN Run
6 CAN Fail
7 CAN termination
8 CAN address hundreds selection
9 CAN address tens selection
10 CAN address units selection
11 I/O connections
12 Plate fastening holes
13 Relay connections
Figure 11 shows a general card with type 1 I/O connectors.
Depending on the customer's requirements, the card may also
have been supplied with other types of connector.
The use of the single connector is identified by its silkscreened
details.
Figure 12 - Types of I/O connector
18
Figure 11 - CAN-IO module element position
Tipo 1
Tipo 2
Tipo 3
Connector / indicator
Yellow LED
Green LED
Terminal block
DB9 M (D-sub 9 pin male)
Green LED
Red LED
Switch
Switch
Dial
Dial
Power
The CAN-IO module must be connected to a 24 Vdc power
supply unit. The same 24 Vdc power supply can feed several
devices (controller and CAN-IO modules).
Make sure that the current issued by the power supply is
higher than the total maximum current absorbed by all the
devices connected.
Figure 13 - CAN-IO module multiple power supply
Note
programme running
only in CAN-IO modules with relay
80990B_MHW_CAN-IO_12-2016_ENG
+VI24
GNDI