Table of Contents
Advertisement
Displaying area
1
2
3
4
5
1 CURRENT DATE AND TIME
2 TIME LEFT TO PERIODICAL CHECK (ECS 24 HOURS or ECS72 HOURS)
left to the periodical check. Touch this area to display the messages relating to the checks to be carried out by the SERVICE
(Technical Service). Press
(ECS 24 hours or ECS 72 hours)
3 TDS VALVE(Salinity Control Device)
TDS
menu of the
system. When the
4 ESTIMATED OPERATING POWER
steady on if set in the parameters or flashing if active. Touch this area to access the configuration menu of the burner
5 GAS FLOW RATE
(if the meter is installed)
6 BLOWDOWN VALVE
; the valve opening is indicated by an animation. Touch this area to access the configuration menu of the
valve. When the automatic drain is disabled, below the valve, a red indication appears
7 ESTIMATED COMBUSTION EFFICIENCY
8 FLAME PRESENCE
9 MEASURED CO
2
10 TDS VALUE
(Salinity Control Device). Touch this area to access the configuration menu of the TDS system. When the
disabled, below this value, a red indication appears
11 WATER DELIVERY FLOW RATE
12 PUMPS OFF / PUMPS 1 and 2 ON with relevant modulation percentage
water feed pumps. When a pump is on, the animation indicates the water flow towards the generator
13 FLUE GAS RECOVERY UNIT
14 WATER LEVEL
; touch this area to access the configuration menu of the water feed pumps
15 GENERATOR START-UP - GENERATOR STATUS
them and preset the generator for start-up, press the electromechanical button "I". The icon is flashing green when the safety
circuits are closed (boiler ready). To open them and stop the generator, press the electromechanical button "0". The button
turns steady green if it is pressed while flashing, thus operating the burner (steam production start) and, when pressed again,
the burner stops. The setpoint pressure value is indicated under this key
16 AMBIENT TEMPERATURE
design values (+ 5°C minimum + 50 °C maximum)
17 GENERATOR PRESSURE
18 STEAM FLOW RATE
(if the meter is installed)
Adjustment and control system
18
17
(in display-only mode) to set or edit them, select "user level / general parameters / display-date-time
"OK"
to shift to next message and, once finished, the time to next check will be automatically set
; The valve opening is indicated by an animation. Touch this area to access the configuration
TDS
is disabled, below the valve, a red indication appears.
; thermal power estimated on the basis of the burner testing data. SOFT START will be shown
(if the meter is installed)
; the temperature indicated is detected at the energy saver flue gas outlet
; the icon is white when the safety circuits are open (boiler not ready). To close
(in display-only mode). It indicates the ambient temperature allowing to check that it is within the
; touch this area to access the pressure configuration menu
16
15
6
7 8 9 10
11
; The message flashes when there are less than two hours
. Touch this area to access the configuration menu of the
14
13
12
TDS
is
27
Advertisement
Table of Contents
