Table of Contents
Advertisement
TURBULATOR ASSEMBLY
To assemble the turbulators supplied with the boiler, open the door and insert the turbulators completely into the smoke pipes,
until they penetrate by at least 100 m.
The dimensions, diameter and length (ØxP) and the quantities (no.) of the turbulators (Tb) for the various models, are specified in
"Hydraulic fittings"
the
table in paragraph
ELECTRICAL CONNECTIONS
ECOVAPOR
The
feature a control panel (IP 55 insulation class) to be completed by fitting the two factory equipped connectors to
the various generator components. Panel model depends on the version of the ordered generator and the specific and detailed
wiring diagram is present inside the panel. The connections outside the generator must be carried out by
compliance with the Technical Standards and with the local National Legislation in force in the country of use.
IMPORTANT
m
– Connect the generator to an efficient earthing system.
lack of earthing and failure to comply with the wiring diagram.
– Check that the panel power supply complies with the wiring diagram supplied.
– Make sure the generator is properly earthed.
– Check the plant's electrical system.
PROHIBITION
d
– Do not use the water and heating system pipes for the
– Do not step on or damage the protective sheath of the cable with any other mean.
Installation
"Dimensions and fittings"
ICI CALDAIE S.p.A.
earthing connections
Qualified Personnel
is not liable for any damage caused by the
.
in
49
Advertisement
Table of Contents
