Table of Contents
Advertisement
Installation of accessories
▶ Insulate all pipes and connections.
▶ Install the pool module ( Instructions for the pool module).
▶ Set the elapsed time of the swimming pool diverter valve during
commissioning ( instructions of control unit).
▶ Make the necessary settings for the swimming pool mode (
instructions for control unit).
1
1
2
M
VC1
Fig. 23 Example showing swimming pool installation
[1]
Swimming pool module
[2]
POOL
[VC1] Swimming pool mixer
[HS] Heating system
8.11
Cooling only with fan convectors
NOTICE:
Material damage due to moisture!
Without full insulation against condensation, moisture can attack
neighbouring materials.
▶ In cooling mode, all pipes and connections up to the fan convector
should be provided with condensation insulation.
▶ Use an insulating material designed for cooling systems with
condensate formation (Armaflex).
▶ Connect the outlet to the drain.
▶ In cooling mode below the dew point, do not use condensation point
sensors.
8.12
IP module
The IP module is installed as standard in a number of products and can
be retrofitted to others as an accessory.
22
HS
M
To take advantage of all the functions, an Internet connection and router
with a free RJ45 output are necessary. This can lead to additional costs.
The Bosch EasyRemote app is required to control the system using a
mobile phone.
The IP module can be used to control and monitor the system via a mobile
device. It is used as an interface between the heating system and a
network (LAN) and also enables the SmartGrid function.
Commissioning
When commissioning, refer to the router documents.
The router must be configured as follows:
• DHCP active
• Ports 5222 and 5223 must not be blocked from outgoing traffic.
• Free IP address available
• Address filtering adapted to the module (MAC filter).
The following options exist for commissioning the IP module:
• Internet
The IP module automatically obtains an IP address from the router. The
name and address of the target server are stored in the factory settings
of the module. Once an Internet connection is established, the IP module
automatically logs on to the BOSCH server.
• LAN
The module does not have to have Internet access. It can also be used in
a local network. In this case, the heating system cannot be accessed
through the Internet, and the IP module software is not automatically
updated.
• App Bosch EasyRemote
When starting the app for the first time, you will be asked to enter the
login name and password set at the factory. These login details are
printed on the data plate of the IP module.
• SmartGrid
With SmartGrid, the indoor unit can communicate with the energy
exchange and modify the operation of the heat pump so that it is at the
maximum output when the price for the power is the most affordable.
For details of the SmartGrid, refer to the website of the energy supplier.
The login data are lost when the IP module is exchanged.
Each IP module has its own login data.
▶ After commissioning, enter the login data in the corresponding field
of the user instructions.
▶ After exchanging, replace with the data for the new IP module.
Alternately, the password can be changed at the control device.
Login data for the IP module
Manuf.
no.:_________________________________________________________________
Login name:_______________________________________________________
Password:_______________________________________________________________
Mac:_____________________________________________________________________
Compress 3000 AWES – 6720892204 (2020/06)
Advertisement
Table of Contents
