Figure 2-3 Initial Screen - ZyXEL Communications Prestige 941 User Manual

Bootbase Version: V1.4 | 6/22/2000 15:41:27
RAM: Size = 4096 Kbytes
FLASH: Intel 8M@3V
Hardware Information:
Mrd Version : 1
Product ID 1000 Hardware Version 1.58
Bridge Mode with Temic Tuner
ZyNOS Version: V2.40(R25)b3 | 6/28/2000 21:59:44
Press any key to enter debug mode within 3 seconds.
............................................................
Check flash
primary RomFile: OK
backup RomFile: OK
copy primary to backup
Erasing.
Start programing..
primary RAS: OK
backup RAS: OK
initialize ch =0, ethernet address: 00:a0:c5:21:fe:21
initialize ch =1, ethernet address: 00:a0:c5:21:fe:22
initialize ch =2, ethernet address: 00:a0:c5:21:fe:23
Press ENTER to continue...
Running BIST test...result was 1000000 ..passed
Chip ID: 3300, rev: 1
SRAM memory test result is 00
Downstream frequency is 627000000 Hz (EIA 91)
Annex B mode selected
Use default MCNS symbol rates.
Stored upstream channel ID is 2
Initial upstream power is 29 dBmV
Board is configured for Temic 4937 tuner
LAN interface set to 10M Half
QAM: lock, FEC: lock
Update channel information to flash
DHCP OK, IP=10.200.0.107
Current Time: Thu Jun 29 10:39:53 2000
==>Registered<==
*** Cable Link UP *** Thu Jun 29 10:39:53 2000
Step 2. Entering Password
The login screen appears after you press [Enter], prompting you to enter the password shown as follows.
For your first login, enter the default password 1234. As you type the password, the screen displays an (X)
for each character you typed.
Please note that if there is no activity for longer than 5 minutes after you log in, your Prestige will
automatically log you out and will display a blank screen. If you see a blank screen, press [Enter] to bring up
the login screen again.
Hardware Installation and Initial Setup

Figure 2-3 Initial Screen

Prestige 941 Cable Router
2-7