Setup; Battery Use And Replacement - pts Diagnostics CardioChek Plus User Manual

Battery Use and Replacement

®
The CardioChek Plus professional analyzer requires four (4) AA 1.5 volt
high-quality alkaline batteries.
When to Replace the Batteries
The analyzer will give you an indication on the display that the batteries
need to be changed. When the display reads REPLACE BATTERIES, no
more tests can be run until the batteries are changed. Always replace the
batteries with high-quality alkaline batteries. It is recommended to keep a
spare set of batteries on hand. To extend battery life, remove the test strip
as soon as a result is displayed. The time/date and results stored in memory
will not be erased when the batteries are changed.
When the REPLACE BATTERIES message is displayed, replace the batteries
with 4 new AA alkaline batteries of the same brand.
Do not use NiCad or rechargeable batteries.
Caution: Improper installation of batteries can result in decreased battery
life or damage to the analyzer.
How to Install/Replace the Batteries:
1. Open the battery door on the back of the CardioChek Plus
professional analyzer by releasing the latch and pulling the door away
from the back of the analyzer.
2. Remove old batteries from the compartment and properly discard.
3. Insert the new batteries into the battery compartment with the positive
(+) terminals correctly facing as marked on the inside compartment.
4. Replace the battery door. To make sure the batteries were installed
correctly, push either of the two buttons on the front of the analyzer to
turn on the CardioChek Plus professional analyzer.
Warning: Dispose of the old batteries properly.
III. SETUP
12