How To Set The Units - pts Diagnostics CardioChek Plus User Manual

How to Set the Units

The CardioChek Plus professional analyzer may be shipped with preset
units. If the SETTINGS menu does not display UNITS, the analyzer is
locked in preset units. The units cannot be changed if the system has
been locked. If your analyzer's units have not been preset, follow the steps
listed below to change your units to mg/dL, mmol/L, or g/L (e.g., in the US,
the correct units for glucose are mg/dL and the units are preset to mg/dL).
1. If the analyzer is off, press either button to turn on the analyzer. Wait for
the display to read INSTALL MEMO CHIP or INSERT STRIP.
Note: If RUN TEST is displayed, go to Step 3.
2. Press Enter. The display will read RUN TEST.
3. Press Next until SETTINGS is displayed.
4. Press Enter, then press Next until UNITS is displayed. If UNITS is not
shown on the display, the units on this analyzer have been locked and
cannot be changed. If UNITS appears on the display screen, proceed to
the next step.
5. Press Enter. The display will highlight mg/dL. If mmol/L or g/L is desired,
press Next until the desired units are highlighted on the display screen
and then press Enter to select.
6. The display will then read UNITS. Press Next until EXIT is displayed.
7. Press Enter to return to SETTINGS.
8. Press Next to return to RUN TEST.
III. SETUP, continued
18