Profi Air DSS 2034 Manual page 12

Start up
Twisting in the socket
• Remove the plastic protector cap from the compressed-air connection (A).
• Wrap a Teflon band around the thread of the socket (B).
• Screw the plug nipple included within the scope of supply into the compressed-air
connection.
Installation of plug attachment / extension
Improper handling when installing a plug element or elongation can cause injuries.
• Disconnect the compressed-air tool from the compressed-air supply before replacing
a plug insert or mounting or replacing the extension.
• Insert the required plug attachment onto the square-shaped part of the drive shaft. Set
the right direction of rotation on the reversing lever:
Reverse slider backwards (R) = anti-clockwise rotation (loosen bolts)
Reverse slider forwards (F) = clockwise rotation (tighten bolts)
Lubrication
In order to avoid damage caused by friction or corrosion, the unit must be lubricated
regularly. Pneumatic tools must be oiled for the entire duration of their service life. We
recommend using a suitable special compressed-air oil.
Attention! Compressed-air tools that are not continuously supplied with oil during ope-
ration will run dry and become defective as a result. In such cases, no warranty claim can
be made.
Lubricate the compressed-air tool again after use, especially if the device will not be used
for a long period of time.
Lubrication options:
• Mist lubricator
A complete maintenance unit contains a mist oiler and is attached to the compressor.
• Manual
If you do not have a mist lubricator, you must insert 3-5 drops of a special compressed-
air oil into the compressed-air connection each and every time before operating the
compressed-air unit.
Lubricate the compressed-air tool after use and if the device will not be used for a long
period of time.
Air pressure and air volume
The compressed-air unit should be operated using a pressure of 6.2 bar. A larger amount
of pressure than the maximum permissible pressure of 7 bar can overload the unit which
can lead to high levels of wear and damage to the machine. Please take into considera-
tion when setting the air pressures that the pressure drops by approx. 0.6 bar at a hose
length of 10 m.
1231670_BDA_ProfiAir_DSS_2034_DL_Schlagschrauber.indd 11
11
13.10.16 14:50