4.1 Introduction
VDSL-related commands supported by the P841C are shown in Table 3-1.The default values for the following
VDSL parameters are:
VDSL PARAMETER
VDSL Mode
VDSL Active
VDSL Upstream Rate
VDSL Downstream Rate
4.1.1
VDSL Mode Command
This command displays the VDSL mode if you don't type a mode and sets it if you do. Use the "vdsl reset" or
"vdsl recon" command to make VDSL reconnect after you set the mode; it does not do this automatically. The
modes are listed in the next table.
The band plan is different for each mode even though the speed may be the same. The following table summarizes
transmission rates and frequency ranges for each VDSL mode supported by the P841C.
VDSL-Related Commands
VDSL- Related Commands
This chapter shows you how to configure VDSL using Commands.
Table 4-1 VDSL Default Values
vdsl mode (mode)
P841C>vdsl mode
vdsl mode: 10BaseS(0)
Figure 4-1 VDSL Mode
Table 4-2 VDSL Mode
MODE
NUMBER
0
10BaseS mode
1
ANSI Mode (ANSI/ETSI Band Plan 998)
2
ETSI Mode (ETSI Band Plan 997)
P841C Central-Side VDSL Modem
DEFAULT VALUE
0 = 10BaseS mode
On
12Mbps
12Mbps
MODE TYPE
Chapter 4
4-1