Figure 3-5 Exit Command; Figure 3-6 P841C Help Commands - ZyXEL Communications P841C User Manual

ZyXEL recommend you change your password after your very first login. Store your new
password in a secure place for later reference in case you forget it.
3.4.2 Exit Command
Enter this command to log out. You will then have to re-enter your password to log in again.
System Timeout
Please note that if there is no activity for longer than five minutes after you log in, your P841C will automatically
log you out. When you are logged out, press [ENTER] to bring up the password prompt.
3.4.3 help (or ?) Command
Type or to show all available P841C commands as displayed in the next screen.
help ?
P841C>?
sys
help or ?
exit
passwd
fwupgrade
vdsl uprate [x]
vdsl downrate [y]
vdsl auto [on|off]
vdsl load [lt|nt]
vdsl reset
vdsl reconnect
vdsl status
vdsl clear
vdsl debug [on|off]
vdsl monitor [on|off]
vdsl show
vdsl mode (mode)
vdsl active [on|off]
vdsl autoupg [on|off]
enet status
enet clear
enet speed (lt|nt) (speed)
enet fctrl (lt|nt) [on|off]
enet monitor [on|off]
Configuring the P841C
exit
P841C>exit
Password:

Figure 3-5 Exit Command

- display system status
- show this screen
- logout
- change login password
- upgrade firmware
- set/show VDSL uprate
- set/show VDSL downrate
- set/show VDSL auto rate selection flag
- load VDSL modem code
- reset VDSL chip
- force VDSL reconnect
- show VDSL connect status
- clear VDSL connect status
- set/show VDSL debug flag
- set/show VDSL monitor flag
- show VDSL parameters setting
- set/show VDSL mode
- active/deactive VDSL port
- set/show EEPROM auto upgrade flag
- show ENET counters
- clear ENET counters
- set/show NT ENET speed
- set/show NT ENET full duplex flow control
- set/show ENET monitor flag

Figure 3-6 P841C Help Commands

P841C Central-Side VDSL Modem
3-3