Table 3-1 P841C Help Commands - ZyXEL Communications P841C User Manual

P841C Central-Side VDSL Modem
FIELD
sys Entering this command displays the system status.
help or ? Entering this command shows the Help screen displayed
exit Enter this command to log out of command mode.
passwd Enter this command to change the login password.
fwupgrade Enter this command to upgrade the P841C firmware.
vdsl uprate [x] Type this command to set the VDSL upstream rate to speed "x" or show the current upstream
speed (without "x").
vdsl downrate [y] Type this command to set the VDSL downstream rate to speed "y" or show the current
downstream speed (without "y").
vdsl auto [on|off] Type this command to turn the VDSL auto flag on or off or show the current VDSL auto flag
status (without "on" or "off").
vdsl load [lt|nt] This command causes the P841C to load new VDSL modem code into LT (P841C) or NT
(P841). If LT is specified, the P841C will load the VDSL modem code into the VDSL chip. If
NT is specified, P841C will load the VDSL modem code into the P841 VDSL chip.
vdsl reset Issue this command to cause a software reset to the VDSL Chip. The VDSL link disconnects
temporarily while resetting.
vdsl reconnect Issue this command to cause the P841C to reconnect the VDSL link.
vdsl status Issue this command to show the VDSL connection status.
vdsl clear Issue this command to clear the VDSL connection status counters.
vdsl debug [on|off] Type this command to show the VDSL debug flag status (without "on" or "off") or turn on/off
the VDSL debug flag. When this flag is set (on), VDSL debug messages are displayed.
vdsl monitor Type this command to show the VDSL monitor flag status (without "on" or "off") or turn on/off
[on|off] the VDSL monitor flag. When this flag is set (on) and the VDSL link is up, VDSL parameters
are displayed every three seconds.
vdsl show This command displays your P841C settings.
vdsl write (lt|nt) Write variables to VDSL chipset registers.
addr value -
vdsl mode (mode) This command displays the VDSL mode if you don't type a mode and sets it if you do.
vdsl active [on|off] Use this command to activate or deactivate VDSL.
vdsl autoupg Type this command to show the VDSL auto upgrade status (without "on" or "off") or turn on/off
[on|off] auto upgrade. When auto upgrade is on, the P841C will check the subscriber's modem VDSL
version and automatically upgrade it if it is an earlier version than the P841C's.
enet status Type this command to display P841C and the subscriber's VDSL modem's Ethernet statistics
(if link is up).
enet clear Type this command to clear P841C and the subscriber's VDSL modem's Ethernet statistics (if
link is up).
3-4

Table 3-1 P841C Help Commands

DESCRIPTION
System-related Commands
VDSL-related Commands
Ethernet-related Commands
Configuring the P841C