Maintenance; Repair; Main Groups Of Disposal; Warranty - Linak TECHLINE LA33 User Manual

Chapter 5

Maintenance

• The actuator must be cleaned at regular intervals to remove dust and dirt and inspected for mechanical
damages or wear.
• Inspect attachment points, wires, piston rod, cabinet, and plug, as well as check that the actuator functions
correctly.
• To ensure that the pregreased inner tube remains lubricated, the actuator must only be washed down when the
piston rod is fully retracted.
• The actuator is a closed unit and therefore requires no internal maintenance.
• In order to maintain a proper performance of the spherical eyes and to increase the resistance against
environmental wear, we strongly recommend that the spherical eyes (ball bearings) mounted on actuators
from LINAK are greased with anticorrosive grease or similar.

Repair

Only an authorised LINAK
warranty must be sent to an authorised LINAK service centre.
In order to avoid the risk of malfunction, all actuator repairs must only be carried out by an authorised LINAK
Service shop or repairer, as special tools and parts must be used.
If a system is opened by unauthorised personel there is a risk that it may malfunction at a later date.

Main groups of disposal

LINAK's products may be disposed of, possibly by dividing them into different waste groups for recycling or combustion.
Product
LA33
We recommend that our product is disassembled as much as possible at the disposal and that you try to recycle it.

Warranty

There is an 18 months' warranty on TECHLINE products against manufacturing faults calculated from the production
date of the individual products (see label). LINAK's warranty is only valid in so far as the equipment has been used
and maintained correctly and has not been tampered with. Furthermore, the actuator must not be exposed to violent
treatment. In the event of this, the warranty will be ineffective/invalid. For further details, please see standard terms of
sale and delivery for LINAK A/S.
Note:
Only an authorised LINAK
warranty must be sent to an authorised LINAK service centre.
In order to avoid the risk of malfunction, all actuator repairs must only be carried out by an authorised LINAK
Service shop or repairer, as special tools and parts must be used.
If a system is opened by unauthorised personel there is a risk that it may malfunction at a later date.
The actuator is not to be opened by unauthorised personnel. In case the actuator is opened, the warranty will be invalid.
service centre should repair LINAK actuator systems. Systems to be repaired under
®
Metal scrap
X
service centre should repair LINAK actuator systems. Systems to be repaired under
®
Cable scrap Electronic scrap
X
Page 70 of 76
Plastic recycling or
combustion
X X