Table of Contents
Advertisement
THE ELECTRONICS
DISASSEMBLING
Ensure that the Ultimaker is switched off and disconnected from the power.
1.
Remove the two screws (M3 x 8 mm) with which the cable cover in the back left corner is attached to the frame.
One screw is attached to the left side of the frame and the other one to the back side. Fig. 1 and 2.
Ensure that the build plate is at the bottom position.
2. Remove the cable cover. Fig. 3.
3. Raise the build plate gently by holding it with both hands at the sides as close as possible to the back of the
build plate. Fig. 4.
4. Place the Ultimaker on its right side as seen from the front.
1
3
8
2
4
Advertisement
Table of Contents
