Advertisement
3 Controller
(1) Padlock specification
If the robot is not used, the power switch can be locked with the padlock so that power supply ON cannot be
done easily. The specification is shown in the following.
Enlarged
Padlock (prepare by customer)
<The operation method>
(1) The lock method (power supply OFF)
1) Turn OFF the power switch.
2) Loosen the lock plate fixing screw and make it slide upwards (cover the power switch). Tighten the
fixing screw certainly in that position.
3) Install the padlock (customer preparation) to the hole of the lock plate, and lock it.
The lock is completion
(2) The release method (power supply ON)
1) Remove the padlock.
2) Loosen the lock plate fixing screw and make it slide downward (position which does not cover the
power switch). Tighten the fixing screw certainly in that position.
Lock release is completion.
The lock device which can be used
Fig.3-2 ： Operation lock of the power switch
Names of each part
3-35
Lock plate fixed screw
Lock plate
Dimension of the padlock
A
25mm
POWER switch
Dimension
B
14mm
4mm or less
C
Hide quick links:
Advertisement
