Table of Contents
Advertisement
3
INTERIOR STRAIGHT INSTALLATION - MULTIPLE FLOOR
IF USING THE REDUCED CLEARANCE SUPPORT
(RCS), REFER TO PAGE 6 FOR DIMENSION AND
COLLAR CAN BE DISCARDED.
Step 1. Locate the chimney in a convenient place as
near as possible to the appliance outlet.
Step 2. Cut and frame the openings in the floor, ceiling
and roof where the chimney will pass.
NOTE: It is important to follow the framing dimensions
for the floor openings prescribed in this manual.
CHIMNEY
FINISH SUPPORT
SIZE
5"
12-1/8" x 12-1/8"
6"
12-1/8" x 12-1/8"
7"
14-3/8" x 14-3/8"
8"
14-3/8" x 14-3/8"
10"
* For sloping roofs see size Table 2 on page 3
Step 3. From below push the finish support into
the framed opening. Nail or screw the sup-
port to the framed box using (12) 3" spiral
nails or #8 x 1 1/2" wood screws
(see Figure 6).
8
HOLE SIZE
RADIATION SHIELD
(FSC)
& ROOF
11-3/8" x 11-3/8"
12-3/8'' x 12-3/8''
13-3/8'' x 13-3/8''
14-3/8'' x 14-3/8''
---
16-3/8'' x 16-3/8''
Table 4
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
FINISH SUPPORT (FSC)
Figure 6
*
1. BLACK STOVE PIPE
2. FINISHING SUPPORT
3. INSULATED LENGTH
4. FIRESTOP
5. ATTIC RADIATION SHIELD
6. ADJUSTABLE ROOF FLASHING
7. RAIN CAP
Figure 7
NAILS
7
6
5
4
3
2
1
Advertisement
Table of Contents
