Swagman 80600 Instruction Sheet

INSTRUCTION SHEET
PRODUCT: 80600 Four Bike RV Bumper Mount Rack
• Page 1 of 2
For use on all 4"& 4-1/2" square RV bumpers.
DO NOT exceed 4 bikes on platform.
INSTRUCTIONS
1. Bolt Carrier Frame Bar (C) to Carrier Frame (A) and Stabilizer Bar (D), using 4 Bolts (J & K),
4 Lockwashers (H) and 4 Nuts (I). Do not tighten.
2. Place Stabilizer Bar (B) over carrier, place carrier over bumper and bolt them all together using
2 - 7" Bolts (F), 2 Lockwashers (H) and 4 Nuts (I). Bolt holes without Stabilizer Bar using 6 - 6" Bolts (G),
6 Lockwashers (H) and 6 Nuts (I).
3. Bolt Carrier Frame Bar (C) to Carrier Frame (A), using 4 Bolts (J), 4 Lockwashers (H) and 4 Nuts (I).
4. Tighten all bolts and nuts.
5. Install 2 End Caps (E). Read page 2 for Warnings, Tips and Warranty Information.
E
D
K
J
H
I
LEFT
300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
G
A
C
H
I
H
I
E
G
A
C
J
H
H
I
I
RIGHT
HARDWARE
A – Carrier Frame 2
B – Stabilizer Bar 1
C – Carrier Frame Bar 4
D – Stabilizer Bar 1
E – End Caps 2
F – 3/8" x 7" Bolts 2
G – 3/8" x 6" Bolts 6
H – 3/8" Lockwashers 16
I – 3/8" Nuts 16
J – 3/8" x 2-1/4" Bolts 6
K – 3/8" x 2-1/2" Bolts 2
F
B
A
C
H
I
J
H
I
REV 23/10/19
G
A
C
H
I