Resetting The Zyxel Device; Methods Of Restoring Factory-Defaults; Navigating The Web Configurator - ZyXEL Communications 802.11b/g Wireless Access Point NWA-1100 User Manual

Chapter 2 Introducing the Web Configurator
The management session automatically times out when the time period set in
the Administrator Inactivity Timer field expires (default five minutes). Simply
log back into the ZyXEL Device if this happens.

2.2 Resetting the ZyXEL Device

If you forget your password or cannot access the web configurator, you will need to use the
RESET button. This replaces the current configuration file with the factory-default
configuration file. This means that you will lose all the settings you previously configured.
The password will be reset to 1234.

2.2.1 Methods of Restoring Factory-Defaults

You can erase the current configuration and restore factory defaults in two ways:
Use the RESET button to upload the default configuration file. Hold this button in for about
10 seconds (the lights will begin to blink). Use this method for cases when the password or IP
address of the ZyXEL Device is not known.
Use the web configurator to restore defaults (refer to

2.3 Navigating the Web Configurator

The following summarizes how to navigate the web configurator from the Status screen.
Check the status bar at the bottom of the screen when you click Apply or OK to verify that the
configuration has been updated.
36
Section 14.7 on page 124).
ZyXEL NWA-1100 User's Guide