SaMASZ MOP 120K Operator's Manual page 20

1) Unscrew bolts M10x30 on container frame feet set (it.
20) and insert bolts with heads up in the bracket
channel on the sweeper's body (Fig. 19). Adjust the
container frame set on the bolts, pre-tighten all nuts
(pay attention to washers). Check whether the frame
feet are evenly set on the sweeper's body, and then
tighten nuts.
2) Tighten the sprayer bar (it. 4) with bolts M8x25 to the
bracket I and II of the right and left mounting of the
container (Fig. 20).
3) Before sliding over flexible hose III (it. 7) onto sprayer
nozzle (it. 16) installed on the bar, place hose clamp,
and then slide the hose onto the ending. Secure the hose
from being retracted by tightening the clamp on the
coupling - use the screwdriver (Fig. 21).
4) For installing the set on the sweeper with the side brush,
marginal mounting set (it. 17) should be installed. The
mounting is to be tightened on the side brush shield
(Fig. 22) in round assembly mounting (it. 18). Use
industrial rubber belt (it. 10) delivered to remove any
plays on the mounting by tightening bolt M6x25 to set
the spraying angle to 45° to the ground.
Fig. 22
Prior to operation commencement:
Inspect, and if need be, re-tighten bolts and nuts,
Examine connections on the flexible hose,
Fill the water tank and connect the water pump power supply to 7 PIN socket, being the
tractor's equipment. Start the pump, check whether there are no leaks in the system and the
nozzles work properly.
Operator's manual
- 18 -
Tractor sweeper
MOP
Fig. 19
Fig. 20
Fig. 21