Encrypt Button Problems - ZyXEL Communications ZyXEL PLA-407 User Manual

Chapter 9 LEDs and Troubleshooting
Your Powerline adapters may be placed close to electrical devices such as
3
electrical insect-killers which produce radio waves. These may interfere with the
Powerline signals. Move the adapters further away from such electrical devices.
Your wiring may be old and/or low quality or with a long wiring path.
4

9.5 ENCRYPT Button Problems

This section applies only to PLA-407s with the ENCRYPT button.
The HomePlug light is already on, but I haven't pressed the ENCRYPT button yet.
Your device has already connected to another Powerline device. Press the
ENCRYPT button for more than 10 seconds to release the connection.
The POWER light does not blink when I press the ENCRYPT button.
• Check the device is on.
• Press the ENCRYPT button again, making certain you have pressed the button
for more than one second and less than three seconds.
• The POWER light on some Powerline devices do not blink as part of the
ENCRYPT process. Check your Powerline device is a PLA-407.
• For PLA-407, you cannot use the ENCRYPT button when it is in Low Power
mode. Connect the PLA-407 to a computer/router then try again.
The POWER light blinks two times quickly then pauses, before repeating.
The ENCRYPT process has failed. Press the ENCRYPT button on both devices for
more than 10 seconds, then try to reconnect.
The POWER lights on both devices blink when I press the ENCRYPT buttons, but
the HomePlug light does not turn on.
• Ensure you have pressed the ENCRYPT button on both devices.
82
PLA-407 User's Guide