Bosch BSA 43 Series Product Description page 20

en 20 | BS� ���� | Product description
Item Designation
1 Assessment scale
(hour-glass)
2 Warning lamp (red)
Measured value scales R Provide an analog display of the brake dynamometer, suspension tester and side slip tester mea-
3
Outer scale:
Center scale:
Inner scale
4 Infrared receiver
5 LCDs
6 Automatic button
Indicator lamp (green) R Permanently lit when BSA 43xx is ready for operation.
7
|
1 691 606 210 2010-09-21
Functions
Evaluates the test results and displays operating statuses, fault statuses or device identification
(based on standard traffic light colors):
R Green: The test result complies with legal requirements or is OK.
R Yellow: The test result just about complies with legal requirements or is critical.
R Red: The test result does not comply with legal requirements or is unsatisfactory.
R Does not light in manual mode.
R Permanently lit when automatic mode is active.
R Flashes when the analog display receives an invalid entry via the remote control unit.
R Flashes (red) on start-up of the test rollers.
sured values. Operating statuses, fault statuses or device identification are also displayed.
Brake dynamometer: Braking force [kN]
R Measuring range 0...8 kN
R Red pointer / Right scale: Right braking force
R Green pointer / Left scale: Left braking force
Suspension tester: Road surface adhesion [%]
R Measuring range 0...100 %
R Red pointer / Right scale: Right road surface adhesion
R Green pointer / Left scale: Left road surface adhesion
Toe measurement: Misalignment [mm]
R Measuring range -20 mm/m ... +20 mm/m
The infrared signals of the remote control unit are received and evaluated in the analog display.
R A valid remote control entry is acknowledged by flashing of the green indicator lamp.
The entry is processed.
R An invalid remote control entry is acknowledged by flashing of the red warning lamp.
The entry is rejected.
Display measured values, operating statuses, fault statuses and messages.
R Top / Left: Four-position LCD
R Center: Five-position LCD
R Bottom / Right: Four-position LCD
With differing functions depending on the current operating status of the BSA 43xx:
R In manual mode (normal operation) with vehicle positioned on set of rollers:
Several functions, refer to operating instructions.
R In manual mode (normal operation) with vehicle not positioned on set of rollers:
Brief touch of button: Automatic mode is activated.
Longer touch of button: Super automatic mode is activated.
Very long touch of button: Exit from test routine.
R In automatic / super automatic mode:
STOP button, i.e. automatic or super automatic mode is terminated.
R Test routine not active
Brief touch of button: Selects next test routine
Longer touch of button: Starts next test routine
R Flashes when the analog display receives a valid entry via the remote control unit.
R Flashes if a fault has occurred on switching on the BSA 43xx.
Robert Bosch GmbH